How to replace impeller bushing on Toro Power Max Snowblowers Part 1 Rv 1

4 Views
R Sloan
R Sloan
11 Nov 2020

Credit to 351benov8 for pointing out the error in my previous video Also suggested taking out the impeller end play by tightening up the pulley to bushing I prefer to leave some play in the pulley to let the impeller belt line up fully during operation if the pulley is too far forward it pulls the belt at an angle and can cause uneven belt wear That is just my preference This video shows how to replace the impeller bushing bearing on your Toro PowerMax 826LXE snow blower and other models Parts used Toro Impeller Belt 106-4498 Toro Bearing flange kit 12-8789 Due to factors beyond the control of Alex S Multikhaz it cannot guarantee against unauthorized modifications of this information or improper use of this information Alex S Multikhaz assumes no liability for property damage or injury incurred as a result of any of the information contained in this video Alex S Multikhaz recommends safe practices when working with power tools automotive lifts lifting tools jack stands electrical equipment blunt instruments chemicals lubricants or any other tools or equipment seen or implied in this video Due to factors beyond the control of Alex S Multikhaz no information contained in this video shall create any express or implied warranty or guarantee of any particular result Any injury damage or loss that may result from improper use of these tools equipment or the information contained in this video is the sole responsibility of the user and not Alex S Multikhaz

  • Select a category

    4

Scroll More Videos


DreamHost
0 Total Comments Sort By

There no comments on your videos ATM